Page 1 of 1

Welcome!!!

Posted: Tue Jun 23, 2015 11:08 pm
by CRT
Please join me in welcoming our newest forum sponsor: Whidden Gunworks

You can visit Whidden Gunworks online at: http://www.whiddengunworks.com/
Or call them at: 229-686-1911
Email: info@whiddengunworks.com

Re: Welcome!!!

Posted: Wed Jun 24, 2015 9:50 am
by Nor Cal Mikie
Welcome to the Small Caliber Club.
IMHO, Whidden Gunworks is one of the "Better" outfits in business.
Let's see, V Blocks? Got 3 of them or is it 4. (I've lost count)
Tactical bolt handles? 4 or 5. I'd have to go look. ;) (no longer on their sales list) I may have bought all of them. ;)
Good products, good folks to deal with and GREAT customer service. Couldn't ask for too much more. 8-) 8-)

Re: Welcome!!!

Posted: Wed Jun 24, 2015 12:23 pm
by L.Sherm
I gotta say the set I have for my 20SCC are pretty spectacular. Welcome aboard

Re: Welcome!!!

Posted: Wed Jun 24, 2015 6:04 pm
by BillK20SCC
Same here, the set of 20 SCC dies are great. I have both their and Brad's bushings. :D Bill K :)

Re: Welcome!!!

Posted: Mon Jul 02, 2018 12:05 am
by Silverfox
I have a Whidden full length bushing die I use for my Tikka Master Sporter in .22-250. This rifle has a 1 in 12 twist Brux barrel. Once I got the die set up properly, it does and excellent job.

Re: Welcome!!!

Posted: Mon Jul 02, 2018 9:04 am
by Nor Cal Mikie
I DID have an issue when they built my 20 TCM Wildcat Micro Top seating die. Die looked great till I tried to seat a couple of bullets. After giving it a close look, found out it wasn't machined enough for the seating stem to reach the bullet tip. Sent it back along with a few cases and bullets so they could seat a few. Got it back in about a week. Seated a few bullets and all is well NOW. I'am pretty easy so delays are something I don't get too upset about "anymore". Life is WAY too short (and getting shorter) to get upset. ;)

Re: Welcome!!!

Posted: Mon Jul 02, 2018 6:04 pm
by BillK20SCC
Re: Welcome.. I must add to this thread, that I am more than satisfied with the set of FL/bushing die and seater, that I obtained from Whidden for my 20 SCC. They have worked just great. Believe the workmanship and quality is really fine. BIll K :)